| Products | Shop Online | Commercial Solutions | Interactive Tools | Motivation & Community | Training & Competition | Service | Company |
Model E Assembly
|
The Indoor Rowers require very little assembly. The Model E Indoor Rower requires the installation of the front and rear legs, the monitor arm and pickup cable, and attaching the PM4 monitor itself — a total of 10 screws. We include the necessary tool and clear instructions with lots of pictures. Allow about 30-45 minutes for the job. Installing the Rear LegInstallation of the rear leg includes removing the rear bumper from the monorail and installing it on the rear leg (steps 2 and 3 in the assembly instructions). To assist you, the following video clip demonstrates this procedure. Model E Rear Leg Assembly Runtime: 1 minute 16 seconds Click play button to view. Connecting the Monorail End with the Flywheel EndOnce all the installation steps are completed you will need to connect the monorail end of the rower with the flywheel end. This procedure is illustrated in the assembly instructions, or you can view the procedure in the video clips below. Framelock Connection Runtime: 17 seconds Click play button to view. Assembly InstructionsDownload the assembly instructions in PDF format:  Model E Assembly Instructions
Box 3 Note: The nut and bolt shown as part of the contents for Box 3 are installed in the case back of the PM4; they are not loose in the box. |