Model E Assembly

The Model E Indoor Rower requires the installation of the front and rear legs, the monitor arm, pickup cable, and the PM4 monitor using a total of 10 screws. We include the necessary tool and clear, illustrated instructions. Allow about 30–45 minutes for the job.

Installing the Rear Leg

Installation of the rear leg includes removing the rear bumper from the monorail and installing it on the rear leg (steps 2 and 3 in the assembly instructions). Refer to the following video.

Model E Rear Leg Assembly

1:16 Minutes

Connecting the Monorail End with the Flywheel End

Once all the installation steps are completed, you will need to connect the monorail end of the indoor rower with the flywheel end. This procedure is illustrated in the assembly instructions, or refer to the following video.

Framelock Connection

0:17 Seconds

Assembly Instructions

Model E Assembly Instructions

Box 3 Note: The nut and bolt shown as part of the contents for Box 3 are installed in the case back of the PM4; they are not loose in the box.